STOP

Always wear protective gloves before hand cleaning. 

The bottom chuck, retractable blade guard and the blade are removable.

To remove the bottom chuck, turn it clockwise by hand. To loosen use a wrench, or screw driver for leverage. Wash, rinse and sanitize.

To remove the retractable blade guard, pull the ring of the snap pin at the rear bracket of the Spirocutter; slide the pivot arm and the leading edge of the blade guard forward and away from the remaining attached blade guard.  Loosen the two lobed stem bolts, which hold the blade guard to the back of the gear motor.  Carefully lift and slide the guard over the exposed blade. Wash, rinse, and sanitize.                                                                                        

CAUTION: Place the two piece guard over the exposed blade if it is not going to be removed.  Then proceed with hand cleaning, rinsing and sanitizing.

To remove the blade; carefully loosen the two bolts on the bottom side of the blade. Carefully remove the blade ring and blade from the blade hub. Wash, rinse and sanitize.

888-887-HAMS  * 817-877-3266 (Phone)
817-877-3742 (Fax) *  info @spirocut.com (E-mail)